Refitting

1. Slacken the screws (1a) and remove rear brake holder plate (1b) complete with brake shoes and cylinder.

• Carry out Op. 4420A30 Rear suspension DAMPER (one) lh or rh - R+R.
• Carry out Op. 4420A40 Rear suspension COIL SPRING (one) lh or rh - R+R.

1. Slacken the nuts (1a) of the fastening screws and remove the wishbone (1b).

Refitting

Before refitting the wishbone, check that it has no cracks or distortions, that there are no signs of wear on the stub axle and that the flexible bushes are intact. If not, change the complete wishbone.

• Assemble the wishbone and fasten it with its screws.
• Tighten the nuts of the fastening screws to the specified torque

• Complete with Op. 4420A40 Rear suspension COIL SPRING (one) lh or rh - R+R.
• Complete with Op. 4420A30 Rear suspension DAMPER (one) lh or rh - R+R.
• Assemble the rear brake holder plate complete with brake shoes and cylinder and tighten the fastening screws to the specified torque

• Re-position the rigid pipe to the rear drum brake cylinder and fit it in the clamp on the wishbone.
• Using the tool, tighten the rigid pipe to the rear drum brake cylinder to the specified torque

• Keeping the end of the rear brake intermediate hose locked with the wrench, using the tool, tighten the rigid pipe to the rear cylinder to the specified torque

(Cont.d.)