Reassembly (page 2 of 2)

(Continue Op. 7090A46)

1. Apply weldable paint on zones affected by grinding.

1. Position rear outer trim and fasten it with self-locking clamps.
2. Position rear inner trim and fasten it with self-locking clamps.
3. Tack spare parts with some welding spots.

• Temporarily place hatchback door with relevant connection and lock striker, then check alignment and courtesy lamps.

1. Weld rear trim with a spot welder

Note: Weld with a welding spot number equal to the original one.

2. Weld with a MIG welder at arc welding the rear trim connection to rear shelf.

• Correct possible plate deformations with shaped stake and hammer.

1. Remove welding residuals with disk grinding wheel.

• Apply inhibitor on zones affected by welding.
• Seal connections between rear trim and body with prescribed sealant.

(Cont..)