Workshop Manuals Factory service & repair Fiat
Fiat Seicento Factory Service Manual (1998-2010)11 · 70 Bodywork
11 · Body & interior

Reassembly

Make
Fiat
Model
Seicento Factory Service Manual
Year
1998–2010
Section
Body panels, replacement and repair › Reassembly
70 BodyworkReassembly · page 1 of 2

(Cont. Op.7090A54)

  • Remove rear wing.
Diagram of the rear wing removal area showing the cut line around the window and lower body panel, with callout number 1 pointing to the wing edge.
  • Clean door sill edges from PVC treatment.
  • Remove welding spots along whole perimeter of rear wing edge with a chamfering machine.
  • Remove plate off-cuts from rear wing.
  • Straighten edges of rear wing seat with hammer and shaped stake.
  • Remove welding spot residuals with disk grinding wheel.
  1. Apply weldable paint on zones affected by grinding.
Top row shows four tools: a pneumatic chisel, a hammer on a block, a rotary tool, and a can with a brush. Below is a diagram of the car's rear interior structure showing the wing mounting area, with callout number 1 pointing to the inner reinforcement.

Reassembly

Note: Rear right wing should have assembled the reinforcement for tank plug.

Inset detail showing the circular opening in the rear wing with bolt holes around its perimeter.
Detail of the rear wing edge being positioned against the car body, showing alignment points.
  • Drill rear wing to prearrange it to MIG welding.
  • Remove on whole perimeter of spare part outer and inner side the inhibiting treatment with disk grinding wheel.

(Cont..)

Parts & tools for this job For 1998 Fiat Seicento

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.