Reassembly

(Continue Op. 7090G90)

• Remove welding spots along whole perimeter of floor edge with chamfering machine.
• Remove plate off-cuts from floor.
• Straighten plate edges of floor seat with hammer and shaped stake.
• Remove welding spot residuals with disk grinding wheel.

1. Apply weldable paint on zones affected by grinding .

Reassembly

1. Cut spare part at shown level.
2. Carry out some equidistant holes on spare part as shown on figure.
• Remove inhibiting treatment with disk grinding wheel on whole perimeter of spare part inner and outer side.
• Apply weldable paint on zones affected by grinding.
3. Weld rear safety belt brackets with spot welder.

Note: Weld with a welding spot number equal to the original one.

• Weld spare wheel supporting bracket with spot welder.

Note: Weld with a welding spot number equal to the original one.

1. Position spare part by overlapping it to body and check right positioning.
• Fasten spare part with self-locking clamps.
• Tack spare part with some welding spots.
• Check alignment and courtesy lamps.

1. Weld floor near wheel arch with spot welder.

Note: Weld with a welding spot number equal to the original one.

2. With MIG welder carry out filling welding in previously made holes.

(Cont..)