Workshop Manuals Factory service & repair Fiat
Fiat Seicento Factory Service Manual (1998-2010)11 · 70 Bodywork
11 · Body & interior

Reassembly (page 2 of 2)

Make
Fiat
Model
Seicento Factory Service Manual
Year
1998–2010
Section
Body panels, replacement and repair
70 BodyworkReassembly · page 2 of 2

(Continue Op. 7090A54)

  1. Apply weldable paint on zones affected by grinding.
Three small images showing a grinding tool, a power tool, and a can of paint with a brush
Diagram of a car body panel with a cutout section labeled 1
Close-up diagram of a car door frame outline
  • Position spare part and secure it with self-locking clamps.
  1. Cut two edges of overlapped plate so as to obtain a correct alignment.
  • Remove rear wing.
Diagram of the rear section of a car body with points labeled 1 indicating welding locations
  1. Position rear wing and secure it with self-locking clamps.
  • Tack rear wing with some welding spots.
  • Temporarily place seal,moldings and hatchback door.
  • Temporarily place seal, door lock striker and door.
  • Check alignment and door courtesy lamps.
Top row shows tools (arrows, spot welder, MIG welder), below is a diagram of a car rear wing being welded at point 1
  1. Weld rear wing with spot welder.
Diagram of the upper rear car body showing welding points labeled 1 around the window frame
Diagram of the lower rear car body showing welding points labeled 1 along the bottom edge and wheel arch
  1. Carry out filling welding in holes previously carried out with MIG welder.
  2. Weld rear wing connection with arc welding with MIG welder.

(Cont..)

Parts & tools for this job For 1998 Fiat Seicento

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.