Reassembly (page 2 of 2)

(Continue Op. 7090A54)

• Apply weldable paint on zones affected by grinding.

• Restore sealing between roof panel and ribs with prescribed sealant.

• Stick strip of vibration-damping material on ribs.

1. Correctly position spare part using self-locking clamps.
2. Check hinge holes position of hatchback door.
3. Check that windscreen compartment height is at prescribed level .

• Temporarily place hatchback door and relevant seal.
• Check alignment and courtesy lamps.

1. Weld roof panel with spot welder.

Note: Weld with a number of welding spots equal to the original one.

2. Weld with hard soldering through oxyacetylene blowpipe near roof panel angles.

(Cont..)