Reassembly (page 2 of 2)

(Continue Op. 7090A54)

• Tack spare part with some welding spots.

• Temporarily place door with relevant seal, then check alignment and courtesy lamps.

1. Weld door sill with a spot welder.

Note: Weld with a number of welding spots equal to original one.

2. With MIG welder carry out arc welding of door sill connections.

• Correct possible plate deformations with shaped stake and hammer.

1. Remove welding residuals with disk grinding wheel.

• Apply inhibitor on zones concerned with welding.
• Seal connections between spare part and body.
• Restore PVC treatment.
• Start painting phase following prescribed cycle.