Workshop Manuals Factory service & repair Fiat
01 00 General information and technical data02 10 Engine03 18 Clutch04 21 Gearbox and differential05 27 Axle06 33 Braking system07 41 Steering08 44 Suspension and wheels09 50 Auxiliary units10 55 Electrical equipment11 70 Bodywork12 Diagnosis13 Tests14 Wiring diagrams
Fiat Seicento Factory Service Manual (1998-2010)12 · Diagnosis
12 · Diagnostics

H02 Drift when braking

Make
Fiat
Model
Seicento Factory Service Manual
Year
1998–2010
Section
Steering › H02 Drift when braking
DiagnosisH02 Drift when braking · page 1 of 2

H02 Drift when braking

When braking, the car tends to move rightwards and/or leftwards.

If the fault occurs also without braking, see table H01.

If required, run a road test on a straight, flat road without transversal slopes.

Check the actual deviation of trajectory by braking and loosening - with extreme caution - the hold on the steering wheel.

Preliminarily check:

  • tyre pressure, type and conditions
  • correct wheel fastening
  • correct tyre assembly
Step Validity Operation to be performed Test results
OK ⚠ 🔧
1 CHECK BRAKE CIRCUIT
Check brake circuit intactness
All OK
Go to Step 2
Problems found
Leakages or damaged components in the circuit
Intervention
Replace the components or replace the brake booster unit
PROCEDURE 3330D
2 CHECK PAD TYPE AND SURFACE
Check:
- intactness of pad braking surface (front brakes)
- type of pads (front brakes)
- intactness of caliper braking surface (rear brakes)
All OK
Go to Step 3
Problems found
Braking surfaces vitrified or with traces of grease, oil, water
Intervention
Clean, check and eliminate the causes of the fault. If required, replace the pads PROCEDURE OP. 3310A60 (front) or the calipers 3320B10 (rear)
Pads/calipers not of prescribed type Replace the pads PROCEDURE OP. 3310A60 (front) or the calipers 3320B10 (rear)
3 CHECK DISKS/DRUMS
Check:
- brake disk intactness
- disk type
- brake drum intactness
- drum type
All OK
Go to Step 4
Problems found
Disks/drums worn or damaged
Intervention
Grind the disks PROCEDURE OP. 3310A54 (front) or mill the drums PROCEDURE OP. 3320B38, and, if required, replace them PROCEDURE OP. 3310A50 (front) or 3320B34 (rear)
Disk/drum of different type or size Replace the disks PROCEDURE OP. 3310A50 (front) or the drums 3320B34 (rear)

(Cont..)

Parts & tools for this job For 1998 Fiat Seicento

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.