Compartment covers lids

COMPARTMENT COVERS LIDS

SUBGROUP TESTS

A - LOCATING ENGINE BONNET WIND NOISE

• Tape the various areas indicated in the figure with body builder’s adhesive paper.

• Test on the road gradually bringing the car to the speed at which the noise starts: if the noise persists, check the presence of the plugs and that the cable fair lead rubbers on the flameproof bulwark have been installed correctly.
• Remove the paper from zone A and repeat the road test: if the noise persists, check the plugs on the engine bonnet- mudguard coupling.
• Check also the integrity and correct installation of the anti-wind noise seals (see PROCEDURE OP. 7025A62).
• Remove the adhesive paper from zone B and repeat the road test: if the noise persists, check the integrity and correct installation of the front anti-wind noise seals(see PROCEDURE OP. 7025A62).