Subgroup tests

SUBGROUP TESTS

A - LOCATING TAILGATE WIND NOISE

• Tape the various areas indicated in the figure with body builder's adhesive paper .

• Test on the road gradually bringing the car to the speed at which the noise starts: if the noise persists, check that the tailgate has been taped properly.
• Remove the adhesive paper from zone A and repeat the road test: if the noise persists, check that the tailgate is properly centred (see PROCEDURE OP. 7015A14).
• Remove the adhesive paper from zone B and repeat the road test: if the noise persists, adjust the striker (see PROCEDURE OP. 7015A10).
• Check the seal and if necessary, replace (see PROCEDURE OP. 7015A30).