Refit differential assembly (page 2 of 2)
- Make
- Land Rover
- Model
- Defender 90 Workshop Manual (NAS)
- Section
- Repair
Rear axle and final driveRefit differential assembly · page 2 of 2
Refit
- Ensure mating faces are clean and apply a bead of RTV sealant to axle case flange.
- Support differential unit and position on axle casing.
- Secure with lock nuts and tighten to 40 Nm, 30lbf/ft.
- Align marks on flanges and secure propeller shaft to differential. Tighten bolts to 48 Nm, 35 lbf/ft.
- Refit half shafts. See Rear hub assembly
- Refill axle oil with approved lubricant. See LUBRICANTS, FLUIDS AND CAPACITIES, Information, recommended lubricants and fluids
Parts & tools for this job For Land Rover Defender
- PARTRear wheel bearingSearch: Land Rover Defender rear wheel bearing
- TOOLBearing puller kitSearch: wheel bearing puller kit
- PARTCV boot kitSearch: Land Rover Defender cv boot kit
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.