See evaporator; Refit

16. Extract harness from front of engine

Refit

17. Position harness in footwell and route harness
18. Fit grommet and ’P’ clip to harness.
19. Position harness between centre console and
20. Secure earth eyelet to fusebox bracket.
21. Connect multiplugs to main harness.
22. Position switch harness to RH side of console, fit
23. Connect multiplug to trinary switch and
24. Secure earth eyelet to fender.
25. Connect multiplug to compressor fly-lead.
10. Remove fusebox cover.
26. Secure harness to air conditioning hoses with
11. Disconnect multiplug from main harness.
12. Remove screw securing earth eyelet to fusebox
27. Secure harness to engine harness with tie.

bracket.

28. Fit evaporator.
13. Pull harness from between centre console and
29. Perform leak test on disturbed joints

bulkhead.

30. Carry out system test.
14. Remove grommet from harness.
15. Remove ’P’ clip from harness.

compartment and pass through bulkhead into footwell area. Remove air conditioning harness.

into engine bay, follow evaporator and receiver drier hoses to receiver drier.

bulkhead with multiplugs in fusebox area.

fusebox cover and secure with screws.

condenser fan fly-lead.

ties.

See evaporator; Refit

See Adjustment, System test