NOTE: Align harness brackets to 2

141. Fit crossmember and align fixings. 154. Secure kick-down outer cable lock nut.
142. Remove body jack. 155. Align kick-down cable to linkage and secure
143. Fit nuts and bolts securing chassis crossmember, but do not tighten. 156. Adjust kick-down cable.
144. Fit LH and RH catalyst heat shields to chassis, fit bolts but do not tighten. 157. Fit upper fan cowl and secure with clips.
145. Align LH and RH catalyst heat shields to chassis 158. Align fan cowl to upper retaining brackets and crossmember fixings and tighten all fixings.
146. Clean intermediate to tail pipe flange. 159. Align hand brake cable to lever, fit clevis pin and
147. Fit intermediate pipe to mounting rubber, connect to tail pipe and secure with nuts. 160. Position hand brake gaiter and secure with trim
148. Fit exhaust front pipe. See EMISSION CONTROL, Repair, front pipe/catalytic 161. Secure gearbox and transfer box breather pipes converter; Refit
149. Lower vehicle. 162. Connect inhibitor/reverse light switch multiplug.
150. Fit bolts securing bell housing to engine and 163. Fit hi-low selector housing cover to tunnel. tighten to 46 Nm (34 lbf.ft) 164. Fit carpet to transmission tunnel.

.

165. Fit centre console.

NOTE: Align harness brackets to 2

uppermost bell housing retaining bolts. 166. Refill transfer gearbox oil.

151. Align breather pipe ’P’ clips to rear of RH 167. Refill gearbox oil. cylinder head and secure with bolt.
152. Secure kick-down outer cable to clip on rear of 168. Reconnect battery negative lead. LH cylinder head. 169. Select Hi range gear and park.
153. Secure kick-down outer cable to abutment 170. Remove vehicle from ramp. bracket.

clevis pin. See Adjustment, kickdown cable adjustment

secure with screws.

secure with split pin.

studs.

to harness with cable ties.

• See CHASSIS AND BODY,
• Repair, centre console; Refit
• See MAINTENANCE
• , under vehicle maintenance
• See MAINTENANCE , under
• vehicle maintenance