300Tdi Defender
REAR AXLE AND FINAL DRIVE
5
REPAIR
REAR HUB ASSEMBLY - 110/130
Service repair no - 64.15.01
Remove
1. Loosen rear wheel nuts, jack up vehicle and
lower onto axle stands. Remove road wheel.
2. Release brake pipe clips, remove brake caliper
and brake disc shield bolts. Secure to one side.
WARNING: Take care not to kink brake
hose.
3. Lever off dust cap.
4. Remove circlip from driveshaft.
5. Remove 5 bolts and withdraw driving member
and joint washer.
6. Bend back lock washer tabs.
7. Remove locknut and lock washer.
8. Remove hub adjusting nut.
9. Remove spacing washer.
10. Remove hub and brake disc assembly complete
with bearings.
Hub components
1. Dust cap.
2. Drive shaft circlip.
3. Drive member.
4. Drive member joint washer.
5. Drive member retaining bolt.
6. Lock nut.
7. Lock washer.
8. Hub adjusting nut.
9. Spacing washer.
10. Outer bearing.
11. Hub.
12. Inner bearing.
13. Grease seal.
14. Brake disc
15. Disc retaining bolt.