L322 Range Rover Service Procedures
CAPACITIES, FLUIDS, LUBRICANTS AND SEALANTS
09-2
Fluids
Anti-freeze
Use only Texaco anti-freeze coolant (AFC). This is
an ethylene glycol based anti-freeze (containing no
methanol) with silicate non-phosphate corrosion
inhibitors, to protect the cooling system
CAUTION: If Texaco AFC is unavailable, use any
ethylene glycol based anti-freeze (containing no
methanol) with silicate non-phosphate corrosion
inhibitors.
The cooling system should be drained, flushed and
refilled with the correct amount of anti-freeze solution
at the intervals given on the Service Maintenance
Check Sheet.
After filling with anti-freeze solution, attach a warning
label to a prominent position on the vehicle stating
the type of anti-freeze contained in the cooling
system to ensure that the correct type is used for
topping-up.
Brake fluid
Use only Shell DOT 4 ESL brake fluid.
PAS fluid
Use only Texaco Cold Climate PSF 14315 fluid.
Air conditioning
Use only refrigerant HFC-R134a.
Refrigerant oil
Use only Nippon Denso ND-oil 8.
Refrigerant oil absorbs water and must not be stored
for long periods. Do not pour unused oil back into the
container.
NOTE: The total quantity of refrigerant oil in the
system is 110 cc (3.8 fl.ozs).
CAUTION: Do not use any other type of
refrigerant oil.
Anti-Freeze Concentration
The overall anti-freeze concentration should not fall,
by volume, below 50% to ensure that the anti-
corrosion properties of the coolant are maintained.
Anti-freeze concentrations greater than 60% are not
recommended as cooling efficiency will be impaired.
The following recommended quantities of anti-freeze
will provide frost protection to -36
°
C (-33
°
F):
Engine - Td6
Engine - V8
Concentration
50%
Amount of Anti-freeze to refill
system:
5.5 litres (11.6 US
pints)
Concentration
50%
Amount of Anti-freeze to refill
system:
6.5 litres (13.75 US
pints)
