L322 Range Rover Service Procedures
GENERAL DATA
04-12
Propeller and drive shafts
Front differential
Rear differential
Propeller shafts - type
Front - 50 mm (1.9 in) diameter - nominal with sliding joint and SGF
coupling
Rear - 60 mm (2.4 in) diameter - nominal with constant velocity joints,
flexible coupling and intermediate support bearing
Drive shafts - type
Front - Variable length incorporating constant velocity joints at each end of
shaft
Rear - Fixed length incorporating constant velocity joints at each end of
shaft
Type
Hypoid gear differential with fully floating drive shafts
Rear - 60 mm (2.4 in) diameter - nominal with constant velocity joints,
flexible coupling and intermediate support bearing
Reduction ratio:
⇒
Td6 Model
⇒
V8 Model
4.10:1
3.73:1
Type
Hypoid gear differential with fully floating drive shafts
Reduction ratio:
⇒
Td6 Model
⇒
V8 Model
4.10:1
3.73:1