LR3/Disco 3
Installation
1 .
Using the special tools, install the axle housing bushing.
2 .
CAUTION: Make sure the weight of the axle is always supported.
Using a suitable jack, raise the front of the differential.
Install the axle front retaining bolt.
Tighten to 275 Nm (203 lb.ft).
3 .
Attach the driveshaft to the rear axle drive flange.
Clean the component mating faces.
Attach the driveshaft to the rear axle drive flange.
Tighten the new Torx bolts to 150 Nm (110 lb.ft).
4 .
Install the fuel tank heat shield.
