LR3/Disco 3
Headlamp Assembly (86.40.49)
Removal
Published : Jan 6, 2005
WARNING: Vehicles fitted with Xenon headlamps, the following precautions must be observed. Failure
to comply may result in exposure to ultra violet rays, severe electric shock, burns or the risk of explosion.
Ensure the headlamps are switched off at all times. Eye and hand protection must be worn. Never switch on the
lamps or test the bulbs with the lamp holder released from the headlamp.
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Remove the radiator grille. For additional information, refer to
Radiator Grille (76.55.03)
(Section
501-08)
3 .
Remove the headlamp assembly.
Release the 2 clips.
Disconnect the electrical connector.
4 .
NOTE :
High intensity discharge lamp bulb illustrated.
NOTE :
Do not disassemble further if the component is removed for access only.
NOTE :
If installed, leave the Silica Gel sachet in place.
Remove the headlamp bulb.
Remove the cover.