LR3/Disco 3
High Mounted Stoplamp (86.41.32)
Removal
Installation
Published : Jul 1, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
CAUTION: Always protect paintwork and glass when removing exterior components.
Remove the high mounted stoplamp.
Carefully cut through the sealant using a glazing knife.
Disconnect the electrical connector.
Disconnect the washer jet hose.
3 .
NOTE :
Do not disassemble further if the component is removed for access only.
Remove the washer jet.
1 .
Install the washer jet.