LR3/Disco 3
2 .
Carefully remove the sealant from the body to leave a smooth surface.
3 .
Install the high mounted stoplamp.
Check for correct alignment.
4 .
Remove the high mounted stoplamp.
5 .
Apply etch primer to any bare metal.
6 .
Apply primer over the etch primer.
7 .
Apply activator to the high mounted stoplamp.
8 .
Fit a pre-cut nozzle to the sealer cartridge, remove the lid, shake out the crystals and fit the cartridge
to the applicator gun.
9 .
Apply an 8.0 mm ( 0.30 in ) wide continuous bead of sealant, 15.0 mm ( 0.60 in ) in, from the outer
edge of the high mounted stoplamp as shown.
10 .
Install the high mounted stoplamp.
Connect the washer jet hose.
Connect and secure the electrical connector.
11 .
Connect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)