LR3/Disco 3
Rear Lamp Assembly (86.40.70)
Removal
Published : May 4, 2004
1 .
Open the liftgate and tailgate.
2 .
CAUTION: Always protect paintwork and glass when removing exterior components.
Remove the rear lamp assembly.
Remove the 2 screws.
Release the 2 clips.
Disconnect the electrical connector.
3 .
NOTE :
Do not disassemble further if the component is removed for access only.
NOTE :
Note the fitted position.
Remove the wiring harness.
Release the wiring harness from the 2 clips.
Release the 6 bulb holders.
Release the electrical connector.