Range Rover P38
LAND ROVER V8
7
REPAIR
WATER PUMP - FROM 99MY
Service repair no - 26.50.01
Remove
1. Drain cooling system.
See this section.
2. Loosen 3 bolts securing water pump pulley to
water pump.
3. Remove auxiliary drive belt.
See ELECTRICAL,
Repair.
4. Remove 3 bolts securing pulley to water pump
and remove pulley.
5. Release clip and disconnect coolant hose from
water pump.
6. Remove 9 bolts securing water pump, remove
water pump and discard gasket.
Refit
7. Clean water pump and mating face.
8. Fit new gasket and water pump, tighten bolts to
24 Nm (18 lbf.ft).
9. Connect coolant hose to water pump and secure
with clip.
10. Ensure mating faces of water pump pulley and
flange are clean, fit pulley and tighten bolts to
22 Nm (17 lbf.ft).
11. Fit auxiliary drive belt.
See ELECTRICAL,
Repair.
12. Refill cooling system.
See this section.