Range Rover P38
37
MANUAL GEARBOX
NEW RANGE ROVER
8
REPAIR
14. Disconnect multiplugs from High/Low motor and
output shaft speed sensor.
15. Release harness from 2 clips on transfer
gearbox brackets.
16. Lower gearbox for access.
CAUTION: Ensure engine does not foul
bulkhead.
17. Disconnect neutral switch multiplug.
18. Remove 4 bolts securing remote housing to
gearbox. Position harness bracket aside.
19. Remove selector remote housing from 2 location
dowels.
Refit
20. Ensure all mating faces are clean.
21. Apply a uniform bead of Hylogrip 2000 to sealing
face of remote housing as shown.
22. Position remote housing. Engage remote spigot
into selector yoke.
23. Engage housing to location dowels. Align
harness bracket.
24. Secure remote housing with bolts. Tighten to
25 Nm (18 lbf.ft)
25. Connect neutral switch multiplug.
26. Connect multiplugs to High/Low motor and
output shaft speed sensor.
27. Connect Lucars to transfer box fluid temperature
sensor.
28. Secure harness in clips.
29. Position propeller shaft guard. Secure with bolts.
30. Route hand brake cable through grommet in
transmission tunnel.
31. Fit exhaust front pipe.
See MANIFOLD AND
EXHAUST SYSTEM, Repair.
32. Diesel Vehicles. Fit chassis cross member.
See CHASSIS AND BODY, Repair.
33. Remove jack. Lower lift.
34. Connect handbrake cable to lever. Secure with
clevis pin and clip.
35. Fit seal around gearbox remote housing to
transmission tunnel aperture.
36. Position gear lever. Secure with bolts. Tighten
to
25 Nm (18 lbf.ft)
37. Fit gaiter and ring. Secure with nuts.
38. Fit centre console.
See CHASSIS AND BODY,
Repair.
39. Reconnect battery negative lead.