Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)07 · Brakes
07 · Brakes

Combined sensor inspection (page 2 of 3)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Dynamic Stability Control
BrakesCombined sensor inspection · page 2 of 3
  1. Connect the M-MDS to the DLC-2.
  2. Select the following PIDs, then inspect the lateral acceleration speed and the yaw rate.
    • LAT_ACCL: (lateral acceleration speed)
    • YAW_RATE: (yaw rate)
  3. Lateral acceleration speed inspection
BRAKES – Dynamic Stability Control – figure
Fig. 14: Locating DLC-2 Connector
Courtesy of MAZDA MOTORS CORP.
  1. Verify the LAT_ACCL change when the combined sensor is tilted to the left and right.
    • If there is any malfunction, replace the combined sensor.

Standard

When the sensor is tilted to the right (A):

LAT_ACCL changes negatively.

When the sensor is tilted to the left (B):

LAT_ACCL changes positively.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.