Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)02 · Engine
02 · Engine

Oil pan removal/installation [lf]

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Lubrication › Oil pan removal/installation [lf]
EngineOil pan removal/installation [lf] · page 1 of 2

See also: live page (the same text is also in the 2008 2.0L manual)

ENGINE – Lubrication [LF] – figure
Fig. 5: Removing Oil Filter
Courtesy of MAZDA MOTORS CORP.
  1. Start the engine and confirm that there is no oil leakage.
    • If there is oil leakage, repair or replace the applicable part.
  2. Inspect the oil level. (See ENGINE OIL LEVEL INSPECTION [LF] .)

OIL PAN REMOVAL/INSTALLATION [LF]

WARNING: Hot engine and engine oil can cause severe burns. Turn off the engine and wait until it and the engine oil have cooled.

A vehicle that is lifted but not securely supported on safety stands is dangerous. It can slip or fall, causing death or serious injury. Never work around or under a lifted vehicle if it is not securely supported on safety stands.

Continuous exposure to USED engine oil has caused skin cancer in laboratory mice. Protect your skin by washing with soap and water immediately after working with engine oil.

  1. Remove the battery and battery tray. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  2. Remove the air cleaner. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [LF] .)
  3. Drain the engine oil. (See ENGINE OIL REPLACEMENT [LF] .)
  4. Loosen the water pump pulley bolt and remove the drive belt. (See DRIVE BELT REPLACEMENT

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.