Oil pump removal/installation [lf]
- Make
- Mazda
- Model
- MX-5 (NC) Factory Workshop Manual
- Year
- 2006–2008
- Section
- Lubrication › Oil pump removal/installation [lf]
Courtesy of MAZDA MOTORS CORP.
OIL PUMP REMOVAL/INSTALLATION [LF]
WARNING: Hot engine and engine oil can cause severe burns. Turn off the engine and wait until it and the engine oil have cooled.
A vehicle that is lifted but not securely supported on safety stands is dangerous. It can slip or fall, causing death or serious injury. Never work around or under a lifted vehicle if it is not securely supported on safety stands.
Continuous exposure to USED engine oil has caused skin cancer in laboratory mice. Protect your skin by washing with soap and water immediately after working with engine oil.
- Remove the battery and battery tray. (See BATTERY REMOVAL/INSTALLATION [LF] .)
- Remove the air cleaner. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [LF] .)
- Drain the engine oil. (See ENGINE OIL REPLACEMENT [LF] .)
- Loosen the water pump pulley bolt and remove the drive belt. (See DRIVE BELT REPLACEMENT [LF] .)
- Remove the front suspension tower bar (joint, right side, and left side). (See FRONT SUSPENSION TOWER BAR REMOVAL/INSTALLATION .)
Parts & tools for this job For 2006 Mazda MX-5
- PARTOil filterSearch: Mazda MX-5 2006 oil filter
- TOOLOil filter wrenchSearch: oil filter wrench
- FLUIDEngine oilSearch: Mazda MX-5 engine oil
As an Amazon Associate we earn from qualifying purchases.