Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)02 · Engine
02 · Engine

Engine oil replacement [lf]

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Lubrication › Engine oil replacement [lf]
EngineEngine oil replacement [lf] · page 1 of 2
ENGINE – Lubrication [LF] – figure
Fig. 2: Identifying Mark On Dipstick
Courtesy of MAZDA MOTORS CORP.

ENGINE OIL REPLACEMENT [LF]

WARNING: Hot engine and engine oil can cause severe burns. Turn off the engine and wait until it and the engine oil have cooled.

A vehicle that is lifted but not securely supported on safety stands is dangerous. It can slip or fall, causing death or serious injury. Never work around or under a lifted vehicle if it is not securely supported on safety stands.

Continuous exposure to USED engine oil has caused skin cancer in laboratory mice. Protect your skin by washing with soap and water immediately after working with engine oil.

CAUTION: In case you spill engine oil on the exhaust system, wipe it off completely. If you fail to wipe the spilled engine oil, it will produce fumes because of the heat.

  1. Position the vehicle on level ground.
  2. Remove the oil filler cap.
  3. Remove the oil pan drain plug.
  4. Drain the engine oil into a container.
  5. Install the oil pan drain plug with a new washer.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.