Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)09 · Restraints
09 · Body & interior

Connector removal note

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Air Bag System › Connector removal note
RestraintsConnector removal note · page 1 of 3
  1. Turn the ignition switch to the ON position.
  2. Verify that the air bag system warning light illuminates for approx. 6 s and goes out.
    • If the air bag system warning light does not operate normally, refer to RESTRAINTS -- ON- BOARD DIAGNOSTIC system (air bag system) and perform inspection of the system.

CONNECTOR REMOVAL NOTE

  1. Using a flathead screwdriver, pry out the connector stopper plate.
RESTRAINTS – Air Bag System – figure
Fig. 11: Prying Out Connector Stopper Plate
Courtesy of MAZDA MOTORS CORP.
  1. Disconnect the connector.

PASSENGER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION

WARNING: Handling the air bag module improperly can accidentally deploy the air bag module, which may seriously injure you. Read the air bag

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.