Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)09 · Restraints
09 · Body & interior

Inspection procedure

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Air Bag System › Inspection procedure
RestraintsInspection procedure · page 1 of 2
RESTRAINTS – Air Bag System – figure
Fig. 74: Inspecting SST (Deployment Tool)
Courtesy of MAZDA MOTORS CORP.

INSPECTION PROCEDURE

  1. Follow the steps below to inspect the SST (49 H066 002).
    • If not as indicated in SST INSPECTION REFERENCE TABLE , replace the SST (49 H066 002) because it has a malfunction.

WARNING: Do not use a malfunctioning SST (49 H066 002), otherwise it could cause the air bag module or pre-tensioner seat belt to accidentally operate (deploy).

CAUTION: Because the permissible voltage for the SST (49 H066 002) is 12 V, do not connect a 24 V power source because it will damage the SST. Always connect only a 12 V power source.

SST INSPECTION REFERENCE TABLE

Table incomplete in source. The printed source cuts this table off at the right page edge, so some text in the last column is missing.

StepInspection procedureLight condition
GreenRed
1Connect the power supply red clip to the positive battery terminal, and the black clip to the negative battery terminal.OnOff

2

Connect connectors A and B.

Off

On

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.