Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)09 · Restraints
09 · Body & interior

Inspection of sst (deployment tool)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Air Bag System › Inspection of sst (deployment tool)
RestraintsInspection of sst (deployment tool)

deployed air bag module and pre-tensioner seat belt, wear gloves and safety glasses.

  • Due to the adoption of 2-step deployment control in both the driver and passenger-side air bag modules, depending on the impact force, it is possible that inflator No. 2 might not operate (deploy). Before disposing of the air bag module, always follow the inflator deployment procedures and verify the complete operation (deployment) of inflators No. 1 and 2.
  1. Remove the deployed air bag module or pre-tensioner seat belt.
  2. Put the air bag module or pre-tensioner seat belt in a plastic bag, seal the bag, and then dispose of it.
RESTRAINTS – Air Bag System – figure
Fig. 73: Putting Air Bag Module Or Pre-Tensioner Seat Belt In Plastic Bag
Courtesy of MAZDA MOTORS CORP.

INSPECTION OF SST (DEPLOYMENT TOOL)

  1. Before using the SST (49 H066 002), inspect its operation.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.