Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)09 · Restraints
09 · Body & interior

Seat weight sensor inspection

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Air Bag System › Seat weight sensor inspection
RestraintsSeat weight sensor inspection · page 1 of 2
  • Or, the vehicle is involved in a collision
  1. Have two 20 kg {44 lb} weights ready to use.
  2. Connect the WDS or equivalent to the DLC-2 (16-pin).
RESTRAINTS – Air Bag System – figure
Fig. 24: Identifying DLC-2 Location
Courtesy of MAZDA MOTORS CORP.
  1. Select "Body" from the menu.
  2. Select "Restraints".
  3. Select "Seat Weight Sensor ReZero Procedure".
  4. Perform calibration following the procedures on the WDS or equivalent screen.

NOTE: When "Lightly pat the passenger seat cushion" is displayed on the WDS or equivalent screen, lightly pat horizontally approx. five times on the headrest or upper side of the seat back trim of the passenger-side front seat.

SEAT WEIGHT SENSOR INSPECTION

CAUTION: If any of the following work is performed, perform the seat weight

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.