Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)09 · Restraints
09 · Body & interior

Sas control module configuration

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Air Bag System › Sas control module configuration
RestraintsSas control module configuration
RESTRAINTS – Air Bag System – figure
Fig. 18: Removing/Installing SAS Control Module (With Torque Specifications)
Courtesy of MAZDA MOTORS CORP.
  1. Install in the reverse order of removal.
  2. Turn the ignition switch to the ON position.
    • If the SAS control module is replaced, turn the ignition switch to the ON position for 20 s or more after completing the configuration. (See SAS CONTROL MODULE CONFIGURATION .)
  3. Verify that the air bag system warning light illuminates for approx. 6 s and goes out.
    • If the air bag system warning light does not operate normally, refer to RESTRAINTS -- ON- BOARD DIAGNOSTIC system (air bag system) and perform inspection of the system.

SAS CONTROL MODULE CONFIGURATION

  1. Connect the M-MDS to the DLC-2 Connector.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.