47M0055 (page 7 of 8)
- Make
- Rover
- Model
- 600 Rover 600 Repair Manual - Volumes 1 and 2 - 2nd Edition
- Section
- Repairs
Drive shafts47M0055 · page 7 of 8
| A | Set Ring – replace | H | Inboard Joint – LH manual models |
| B | Inboard Joint – RH all models, LH automatic models | I | Dynamic Damper – LH drive shaft, automatic models only |
| C | Circlip | J | Boot Bands – replace |
| D | Roller | K | Dynamic Damper Band – replace |
| E | Spider | L | Driveshaft |
| F | Stopper Ring | M | Outboard Boot |
| G | Inboard Boot | N | Outboard Joint |
Note:
- Clean the disassembled parts with solvent, and dry them thoroughly with compressed air. Do not wash the rubber parts with solvent.
- Thoroughly pack the inboard joint, outboard joint and outboard boot with joint grease included in the new driveshaft set.
Grease quantity:
Inboard Joint = 120 – 130 g
Outboard Joint = 80 – 100 g
Parts & tools for this job For Rover 600
- PARTWheel bearingSearch: Rover 600 wheel bearing
- TOOLBearing puller kitSearch: wheel bearing puller kit
- PARTCV boot kitSearch: Rover 600 cv boot kit
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.