Leon Mk1
Note
|
1 - | Gearbox |
q | If replaced, the secondary shaft → Chapter → Chapterand differential drive must be adjusted → Chapter |
2 - | Filler cap |
q | Removing → Fig. |
q | Insertion → Fig. |
3 - | Oil empty plug |
q | Allen screw, -30 Nm |
q | Multi-point socket head bolt, 45 Nm |
4 - | Seal |
q | Renew |
5 - | Oil filler plug |
q | Allen screw, -30 Nm |
q | Multi-point socket head bolt, 45 Nm |
6 - | Locking bolt |
q | Adjusting selector mechanism → Chapter |
q | This may be replaced with the gearbox without disassembling |
q | Removing → Fig. |
q | Installation position → Fig. |
q | Insertion → Fig. |
7 - | Bearing sleeve for the control rods |
q | Remove → Fig. |
q | Insertion → Fig. |
8 - | Insertion sleeve |
q | Remove with the gearbox disassembled |
q | Insertion → Fig. |
9 - | Point crown for the inverter shaft |
q | Replace after removing |
q | Remove → Fig. |
q | Insertion → Fig. |
10 - | Outer ring of roller bearing |
q | For secondary shaft for 5th / 6th and reverse gear |
q | Remove → Fig. |
q | Insertion → Fig. |
q | When replacing, the input shaft for 5th / 6th and reverse gear must be adjusted → Chapter |
11 - | Shim |
q | For secondary shaft for 5th / 6th and reverse gear |
q | Adjustment chart → Chapter |
12 - | Outer ring of roller bearing |
q | For 1st to 4th gear output shaft |
q | Remove → Fig. |
q | Insertion → Fig. |
q | When replacing, the input shaft for 1st to 4th gear must be adjusted → Chapter |
13 - | Shim |
q | For 1st to 4th gear output shaft |
q | Adjustment chart → Chapter |
14 - | Outer ring of roller bearing |
q | For differential |
q | Remove → Fig. |
q | Insertion → Fig. |
q | If replaced the differential drive must be adjusted → Chapter |
15 - | Shim |
q | For differential |
q | Adjustment chart → Chapter |
16 - | Bearing socket for the selection shaft |
q | Remove → Fig. |
q | Insertion → Fig. |
17 - | Sealing plug |
q | Releasing → Fig. |
q | Insertion → Fig. |
18 - | Seal |
q | Renew |