18.INSPECT CYLINDER HEAD SET BOLT - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- INSPECTION › 18.INSPECT CYLINDER HEAD SET BOLT - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
18.INSPECT CYLINDER HEAD SET BOLT

| Item | Specified Condition |
|---|---|
| No. 1 journal | 0.117 mm (0.00461 in.) |
| Other journals | 0.102 mm (0.00402 in.) |
If the camshaft oil clearance is more than the maximum, replace the camshaft. If necessary, replace the cylinder head sub-assembly.
g. Completely remove the Plastigage from the camshaft journals.
11101A
18.INSPECT CYLINDER HEAD SET BOLT
a. w/ Washer:
i.

*a Measuring Area *b Washer
Using a vernier caliper, measure the thread outside diameter of the cylinder head set bolt. Minimum diameter:
11.4 mm (0.449 in.) If the diameter is less than the minimum, replace the cylinder head set bolt.
b. w/o Washer:
i.

*a Measuring Area
Using a vernier caliper, measure the thread outside diameter of the cylinder head set bolt. Minimum diameter:
12.8 mm (0.504 in.) If the diameter is less than the minimum, replace the cylinder head set bolt and cylinder head set bolt spacer.
Parts & tools for this job For Toyota Hilux
- PARTEngine gasket setSearch: Toyota Hilux engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.