7.INSPECT INJECTION PUMP DRIVE GEAR - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- INSPECTION › 7.INSPECT INJECTION PUMP DRIVE GEAR - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
7.INSPECT INJECTION PUMP DRIVE GEAR
b.

Using a vernier caliper, measure the crankshaft timing sprocket diameter with the No. 1 chain sub- assembly. Minimum sprocket with chain diameter:
71.26 mm (2.81 in.) If the diameter is less than the minimum, replace the No. 1 chain sub-assembly and crankshaft timing sprocket.
HINT: The vernier caliper must contact the No. 1 chain sub-assembly rollers for the measurement.
13613
7.INSPECT INJECTION PUMP DRIVE GEAR
a. for No. 1 Chain Sub-assembly Side:
i. Wrap the No. 1 chain sub-assembly around the injection pump drive gear. ii.

Using a vernier caliper, measure the injection pump drive gear diameter with the No. 1 chain sub- assembly. Minimum gear with chain diameter:
71.26 mm (2.81 in.) If the diameter is less than the minimum, replace the No. 1 chain sub-assembly and injection pump drive gear.
HINT: The vernier caliper must contact the No. 1 chain sub-assembly rollers for the measurement.
b. for No. 2 Chain Sub-assembly Side:
i. Wrap the No. 2 chain sub-assembly around the injection pump drive gear.
Parts & tools for this job For Toyota Hilux
- PARTGlow plugsSearch: Toyota Hilux glow plugs
- TOOLGlow plug socketSearch: glow plug socket
- TOOLDiesel compression testerSearch: diesel compression tester
As an Amazon Associate we earn from qualifying purchases.