- Omega B Workshop Manual
- General Vehicle Information
- A Maintenance, Body and Chassis Sheet Metal Parts, Frame
- B Paint
- C Body Equipment
- D Heating, Ventilation, Air Conditioning (HVAC)
- E Front Wheel Suspension, Wheels and Tyres
- F Rear Axle and Rear Wheel Suspension
- H Brakes
- J Engine and Engine Aggregates
- Repair Instructions
- Description and Operation
- Labour Time Allowances
- Diagnostic Information and Procedures
- Other Information
- Technical Service Bulletins
- Technical Information
- OHC Petrol Engine
- DOHC Petrol Engine
- Diesel Engine
- Repair Instructions
- Description and Operation
- Special Tools and Equipment
- Diagnostic Information and Procedures
- Technical Service Bulletins
- Technical Information
- General
- Repair Instructions
- Measuring oil consumption
- OHC Turbo Diesel Engine (25 DT, X 25 DT) - Engine Identification/Engine Number Number
- Ribbed V-belt Tensioner, Check
- Compression, Check
- Pressure Loss, Check
- Oil Pressure, Check
- Oil Temperature, Measure
- Oil Consumption, Measure
- Timing, Check
- Timing, Adjust
- Charge Pressure, Check
- AC Condenser Ribbed V-belt, Remove and Install
- Remove and Install Air Cleaner Housing (25 DT)
- Cylinder Head Cover, Remove and Install
- Intake Manifold, Remove and Install
- Exhaust Manifold, Remove and Install
- Cylinder Head, Remove and Install
- Engine Oil with Oil Filter Change
- Cooling System, Top Up and Bleed
- Cooling System, Check for Leaks
- Visco-fan, Remove and Install
- Visco-fan Coupling, Remove and Install
- Auxiliary Coolant Pump, Remove and Install
- Support - AC Compressor, Remove and Install
- Engine, Remove and Install
- Engine, Repair Using Short-block
- Turbocharger, Remove and Install
- Charge Air Pipe, Remove and Install
- Fuel System, Bleed - General Information Information
- Injection Lines, Remove and Install Install
- Injector Nozzle, Check
- Fuel Cutoff Solenoid Valve, Remove and Install
- Fuel Injection Pump, Remove and Install
- Charge Pressure Sensor, Remove and Install
- Charge Air Temperature Sensor, Remove and Install (25 DT)
- Control Unit, Remove and Install
- Accelerator Pedal, Remove and Install
- Pedal Sensor, Remove and Install Install
- Pre-heater Relay, Remove and Install
- Illustration: Starter
- Starter, Disassemble and Assemble
- Alternator, Remove and Install
- Intercooler, Remove and Install / Intercooler Fan, Remove and Install install
- Delivery Start, Check and Adjust (Static)
- Sealing, Lubricating and Locking Agents (25 DT, X 25 DT)
- Torque guide values (25 DT, X 25 DT)
- Attaching Parts from Cylinder Head, Detach and Reattach
- Manual Transmission from Engine, Detach and Reattach
- Description and Operation
- Component Locator
- Specifications
- Special Tools and Equipment
- Diagnostic Information and Procedures
- Other Information
- Technical Service Bulletins
- Technical Information
- Seals and Seal Rings
- Ribbed V-Belt
- Fuel Pump
- Engine Damping Block
- Oil Circulating
- Timing Gear Case
- Cylinder Block
- Cylinder Head
- Vacuum Pump
- Fuel Injection Systems
- Engine Electrics
- Cooling System
- Turbo-Charging
- K Clutch and Transmission
- L Fuel and Exhaust System
- M Steering
- N Electrical Equipment and Instruments
- R Accessories