- Omega B Workshop Manual
- General Vehicle Information
- A Maintenance, Body and Chassis Sheet Metal Parts, Frame
- B Paint
- C Body Equipment
- D Heating, Ventilation, Air Conditioning (HVAC)
- E Front Wheel Suspension, Wheels and Tyres
- F Rear Axle and Rear Wheel Suspension
- H Brakes
- J Engine and Engine Aggregates
- Repair Instructions
- Description and Operation
- Labour Time Allowances
- Diagnostic Information and Procedures
- Other Information
- Technical Service Bulletins
- Technical Information
- OHC Petrol Engine
- DOHC Petrol Engine
- Repair Instructions
- Injectors, Remove and Install
- Hot Film Mass Air flowmeter, Remove and Install
- Fuel Pressure, Check
- Oxygen Sensor, Remove and Install (X 20 XEV)
- Idle Speed Stepper Motor, Remove and Install (X 20 XEV)
- Fuel Pump Relay, Remove and Install Remove and Install
- Reverse Polarity Protection Relay, Remove and Install
- Intake Air Temperature Sensor, Remove and Install (X 20 XEV)
- Coolant Temperature Sensor, Remove and Install
- Engine Control Unit, Remove and Install (X 20 XEV)
- Tank Vent Valve, Remove and Install (X 20 XEV)
- Starter - DOHC II
- Alternator - DOHC II
- Engine, Remove and Install 2001)
- Automatic Transmission with Torque Converter from Engine, Remove and Install
- Marking of engine blocks or short blocks
- Description and Operation
- Specifications
- Diagnostic Information and Procedures
- Other Information
- Technical Service Bulletins
- Technical Information
- General
- Seals and Seal Rings
- Ribbed V-Belt
- Fuel Pump
- Engine Damping Block
- Oil Circulating
- Timing Gear Case
- Cylinder Block
- Cylinder Head
- Pre-volume Chamber
- Diesel Engine
- Fuel Injection Systems
- Engine Electrics
- Cooling System
- Turbo-Charging
- K Clutch and Transmission
- L Fuel and Exhaust System
- M Steering
- N Electrical Equipment and Instruments
- R Accessories