Engine oil delivery pipe to turbocharger - r + r

Operation 1084B40 · Engine oil lubrication circuit

1.9 JTD 8V

Removing

- 1072C44 exhaust manifold heat shield on bulkhead - r+r

1. Unscrew the retaining bolts

2. Open collar (2a) and remove the rigid pipe carrying exhaust gas to the EGR (2b).

1. Undo connector and disconnect engine oil supply pipe to the turbocharger, turbocharger side.

Raise the vehicle.

2. Undo connector (2a) and remove engine oil supply pipe to the turbocharger (2b).

Refitting

Fit the engine oil supply pipe to the turbocharger and fix it to the crankcase tightening the connector to the recommended torque.

Lower the vehicle.

Connect the engine oil supply pipe to the turbocharger and secure it by tightening the connector to the specified torque.

Fit the rigid pipe carrying exhaust gas to the EGR and tighten the bolts securing it to the exhaust manfold.

- 1072C44 exhaust manifold heat shield on bulkhead - r+r

1.9 JTD 16V

Removing

Position the vehicle on the ramp.

Proceed with removal - 1016A10 sound-proofing cover - r + r.

Proceed with removal - 7055B54 under-engine guard - r r.

1. Undo the bolts (1a) and remove the exhaust manifold heat shield (1b).

1. Undo the connector (1a) and disconnect engine oil supply pipe to the turbocharger (1b), crankcase side.

Proceed with removal - 1088D24 rigid pipe for coolant inlet to water pump - r + r.

1. Undo the nuts (1a) and remove the upper exhaust manifold heat shield (1b).

1. Undo the connector (1a) and disconnect the engine oil supply pipe to the turbocharger (1b), turbocharger side and remove it.

Refitting

1. Place the engine oil supply pipe to the turbocharger (1a) back in its housing, connect it to the turbocharger and secure it by tightening the connector (1b) to the recommended torque.

Place the upper exhaust manifold heat shield back in its housing and fix it using the nuts.

Proceed with refitting - 1088D24 rigid pipe for coolant inlet to water pump - r + r.

1. Connect the engine oil delivery pipe to the turbocharger (1a), crankcase side, and tighten the connector (1b) to the recommended torque.

Place the lower exhaust manifold heat shield back in its housing and fix it using the bolts.

Refill the engine cooling system with coolant - 0010T20 coolant change.

Proceed with refitting - 7055B54 under-engine guard - r r.

Proceed with refitting - 1016A10 sound-proofing cover - r + r.

Remove the car from the ramps.