Workshop Manuals Factory service & repair Alfa Romeo
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Alfa Romeo 147 Factory Service Manual (2000-2004)19 · Wiring diagrams and electrical functions
19 · Electrical

ELECTRIC FRONT WINDOWS - Description

Make
Alfa Romeo
Model
147 Factory Service Manual
Year
2000–2004
Section
Electrically activated devices › ELECTRIC FRONT WINDOWS - Description
Wiring diagrams and electrical functionsELECTRIC FRONT WINDOWS - Description

ELECTRIC FRONT WINDOWS - Description

Description

The control unit built into the controls unit on the door controls the operation of the driver's and passenger's electric window motors.

The driver's and passenger's motors are controlled in both manual and automatic mode, in accordance with the following logic:

For the driver's window:

  • if the button is pressed for between 60 and 300 milliseconds, the operation is manual: the window closes/opens only when the button is pressed;
  • if the button is pressed for over 300 milliseconds, the operation is instead automatic: even if the relevant button is released, the window continues to close/open as far as the end of travel or until the anti-collision safety system intervenes, if applicable;
  • a subsequent press on the button during movement of the window locks it in its current position;
  • if the button is pressed for less than 60 milliseconds, it is ignored (it is considered to have been knocked accidentally).

for the passenger's window:

  • closing is only manual;
  • opening is automatic, the same as for the driver's window

In the case of inconsistent commands issued simultaneously from the driver's and passenger's side, there is no movement.

At each press of the electric windows control buttons, a confirmation beep is emitted by the buzzer in the instrument panel.

The control unit of the controls unit on the door also acquires information on the possible presence of an obstacle during movement of the window during closing via the anti-collision seals: in this case the window travel stops immediately and is reversed; this happens in both manual and automatic operation.

The circuit is controlled by the services relay and protected by two fuses, all located in the unit under the dashboard.

Movement takes place whether the ignition in ON or OFF.

With the ignition on, it takes place as described above; in addition during starting, this relay is temporarily deactivated.

When the ignition is off, the Body Computer keeps the relay activated - which also supplies the door mirrors - for 3 minutes, but deactivates it immediately when one of the two front doors is opened.

Movement is also disabled when the battery voltage is below 10 V.

The windows are automatically opened or closed by the specific prolonged command (over 4 seconds) sent by the remote control button, if the ignition is off; for more details See E3040 CENTRAL LOCKING.

Parts & tools for this job For 2000 Alfa Romeo 147

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.