Engine coolant temperature SENSOR - R.R.
- Make
- Alfa Romeo
- Model
- GT Factory Service Manual
- Year
- 2003–2010
- Section
- Petrol injection system › Engine coolant temperature SENSOR - R.R.
Engine coolant temperature SENSOR - R.R.
Removing
Ensure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).
| Name | Connector | |
|---|---|---|
| Battery | A1B |
Proceed with removal - 1016A40 ignition coil cover on cylinder head- r+r
Proceed with removal - 1048A59 PIPE from flow meter to throttle casing hose - R.R.
1. Disconnect the electrical connection from the engine coolant temperature sensor.
| Name | Connector | |
|---|---|---|
| 1 | Engine temperature sender unit | K36 |
2. Undo and remove the engine coolant temperature sensor.
Refitting
Place the engine coolant temperature sensor back in its housing and tighten it to the recommended torque.
| Fastening | Component | Ø | Value (daNm) | |
|---|---|---|---|---|
| ENGINE COOLANT (MPI TEMPERATURE SENSOR) | M12 | (Thermostat side) 2.7 ÷ 3.3 |
Connect the electrical connection to the engine coolant temperature sensor.
Proceed with refitting - 1048A59 PIPE from flow meter to throttle casing hose - R.R..
Proceed with refitting - 1016A40 ignition coil cover on cylinder head- r+r.
Connect the negative (-) battery terminal
Parts & tools for this job For 2003 Alfa Romeo GT
- TOOLOBD2 scannerSearch: OBD2 scanner
- TOOLDigital multimeterSearch: automotive digital multimeter
- TOOLBack-probe test leadsSearch: back probe test leads
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.