Throttle body intergral with dvl - r r
- Make
- Alfa Romeo
- Model
- GT Factory Service Manual
- Year
- 2003–2010
- Section
- Petrol injection system › Throttle body intergral with dvl - r r
THROTTLE BODY INTERGRAL WITH DVL - R R
Removing
Ensure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).
| Name | Connector | |
|---|---|---|
| Battery | See A1B BATTERY ( BATTERY NEGATIVE ) |
Proceed with removal
Op. 1048A48 THROTTLE HEATER SLEEVE - R R
1. Disconnect the electrical connection from the throttle body integrated with the D.V.L.
2. Undo the bolts (2a) and remove the throttle body integrated with D.V.L. (2b).
| Name | Connector | |
|---|---|---|
| 1 | Throttle body actuator | See N75 THROTTLE BODY ACTUATOR ( CONNECTORS ) |
Remove the gasket.
Refitting
Replace the throttle casing integrated with D.V.L, complete with gasket, back in its housing and fix it tightening the bolts to the recommended torque.
| Fastening | Component | Ø | Value (daNm) | |
|---|---|---|---|---|
| Bolt | BUTTERFLY VALVE CASE/S (MPI) | M6 | (Air chamber side) 0.8 ÷ 1.1 |
Connect the electrical connection to the throttle body integrated with the D.V.L.
Proceed with refitting
Op. 1048A48 THROTTLE HEATER SLEEVE - R R.
Connect the negative (-) battery terminal
If a new throttle casing integrated with D.V.L. is being fitted, carry out the self-learning procedure for the injection/ignition control unit
Op. 1056B81 RUN ELECTRONIC IGNITION/INJECTION CONTROL UNIT (SINGLE) SELF-LEARNING PROCEDURE.
Removing
Ensure that the ignition key is in the OFF postition, then disconnect the battery negative terminal.
| Name | Connector | |
|---|---|---|
| Battery | See A1B BATTERY ( CONNECTORS ) |
Proceed with the removal
Op. 1048A34 SLEEVE(S) FROM FLOW METER TO AIR SUPPLY CAPACITY CASE - R + R.
Proceed with the removal
1056B87 ignition/injection system control unit mount - r r
1. Undo the remaining bolt (1a) and remove the throttle body integrated with D.V.L. (1b).
Refitting
If the thottle body integral with DVL is replaced, run the injection-ignition initialisation procedure
1056B81 run electronic ignition/injection control unit (single) self-learning procedure
Refit the throttle body with integral DVL in its housing and secure provisionally with the bolt.
Tighten the above bolt to the specified torque at the same time as the remaining bolts that secure the ignition/injection control unit mount are tightened.
Proceed with the refitting
1056B87 ignition/injection system control unit mount - r r
Proceed with the refitting
Op. 1048A34 SLEEVE(S) FROM FLOW METER TO AIR SUPPLY CAPACITY CASE - R + R.
Connect the battery terminal (-).
Parts & tools for this job For 2003 Alfa Romeo GT
- TOOLTrim removal tool kitSearch: trim removal tool kit
- PARTTouch-up paintSearch: Alfa Romeo touch up paint
- PARTPanel clip assortmentSearch: Alfa Romeo panel clips assortment
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.