TUNNEL COVER - R.R

Operation 7040L20 · PASSENGER COMPARTMENT FLOOR COVERING

1.2 8v, 1.3 Multijet, 1.4 16v

Removing

- Disconnect the negative battery terminal.

Op. 7040L22 REAR COVER ON TUNNEL - R.R.

- Remove both centre console side trims:

Op. 7040A65 CONSOLE SIDE CLOSING (ONE) - R.R.

Op. 2125C24 GEAR LEVER KNOB - R + R

Op. 2125C02 GEAR CONTROL LEVER OUTER BOOT - R.R.

Op. 7040A28 TRIM ON GEARBOX CONTROL PANEL - R.R.

- Raise the handbrake lever until it is in the end of travel position.

1. Remove the non-slip mats located in the cup holder.

2. Undo the front fixing nuts (2a) and the fixing bolt (2b) located near the handbrake lever.

3. Release the cover on the tunnle and turn it.

1. Disconnect the connector for the USB port (1a) and for the cigar lighter/current socket (1b).

- Remove the tunnel cover.

Refitting

1. Connect the connector for the USB port (1a) and for the cigar lighter/current socket (1b).

- Fit the tunnel cover in place.

- Tighten the front fixing nuts and the rear fixing bolt.

- Reposition the non-slip mats in the cup holder.

Op. 7040A28 TRIM ON GEARBOX CONTROL PANEL - R.R.

- Fit both trims:

Op. 7040A65 CONSOLE SIDE CLOSING (ONE) - R.R.

Op. 2125C02 GEAR CONTROL LEVER OUTER BOOT - R.R.

Op. 2125C24 GEAR LEVER KNOB - R + R

Op. 7040L22 REAR COVER ON TUNNEL - R.R.

- Connect the negative battery terminal.