Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat 500 Factory Service Manual (2007-2024)22 · Fault diagnosis
22 · Diagnostics

Passenger compartment wind noise, lower area (underbody)

Make
Fiat
Model
500 Factory Service Manual
Year
2007–2024
Section
Wind noise › Passenger compartment wind noise, lower area (underbody)
Fault diagnosisPassenger compartment wind noise, lower area (underbody)

PASSENGER COMPARTMENT WIND NOISE, LOWER AREA (UNDERBODY)

1.2 8v, 1.3 Multijet, 1.4 16v

With the vehicle moving, there is noise coming from the lower area of the passenger compartment

Test results
0PRELIMINARY CHECKSAll OKProblems encounteredOperation
Check that the wind noise is actually coming from the underbody.Move on to Step 1

1. The wind noise is coming from the front doors

2. The wind noise is coming from the area of the bonnet

3. The wind noise is coming from the area of the windscreen.

4. The wind noise is coming from the sun roof

5. The wind noise is coming from the rear area

1. Proceed as instructed

See table T001 WIND NOISE FROM THE FRONT DOORS

2. Proceed as instructed

See table T005 BONNET WIND NOISE

3. Proceed as instructed

See table T006 WINDSCREEN WIND NOISE

4. Proceed as instructed

See table T020 WIND NOISE FROM THE SUN ROOF

5. Proceed as instructed

See table T025 WIND NOISE FROM THE REAR AREA

1UNDER-ENGINE GUARD CHECKAll OKProblems encounteredOperation
Check the condition of the under-engine guard and make sure it is correctly fittedMove on to Step 2

1. Under-engine guard

2. Under-engine guard not fastened correctly

1. Replace the under-engine guard

Op. 7055B54

2. Renew the fastening of the partition

2CHECK ON UNDER-FLOOR PANELAll OKProblems encounteredOperation

Check the trim under the floor panel. In particular, check:

- The plugs are present;

- The plugs are correctly fitted;

- The seals are present and in good condition.

End of diagnosisProblems with the trim under the floor panel.Renew the plugs and seals for the trim under the floor panel

Parts & tools for this job For 2007 Fiat 500

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.