Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat 500 Factory Service Manual (2007-2024)01 · General information
01 · General

Planned maintenance programme

Make
Fiat
Model
500 Factory Service Manual
Year
2007–2024
Section
Vehicle introduction › Planned maintenance programme
General informationPlanned maintenance programme

PLANNED MAINTENANCE PROGRAMME

1.2 8v, 1.3 Multijet, 1.4 16v

Planned maintenance programme

Thousands of Km306090120150180
Check tyre condition / wear and adjust pressure, if necessaryXXXXXX
Check operation of lighting system (headlamps, direction indicators, hazard warning lights, luggage compartment, passenger compartment, instrument panel warning lights, etc.)XXXXXX
Check operation of windscreen wash/wipe, adjust jetsXXXXXX
Check windscreen/rearscreen wiper blade position/wearXXXXXX
Check front disc brake pad condition and wearXXXXXX
Check rear drum brake linings condition and wearXXX
Visually inspect condition of: exterior bodywork, underbody protection, rigid and flexible pipes (exhaust - fuel system - braking system) rubber elements (boots - hoses - bushes - etc.)XXXXXX
Check cleanliness of bonnet and boot locks, as well as cleanliness and lubrication of linkagesXXXXXX
Check tension and, if necessary, adjust accesssory drive belts (excluding engines fitted with automatic tensioners)XX
Visually inspect condition of the various drive beltsXX
Check/adjust tappet clearance (1.2 8v petrol versions)XXX
Check/adjust handbrake lever travelXXXXXX
Check evaporation control system (petrol versions)XX
Check rear disc brake pad condition and wearXXX
Change engine oil filter (every 30,000 km for 1.3 Multijet versions)XXX
Top up fluid levels (engine coolant, brake fluid, screen washer, battery, etc.)XXXXXX
Check condition of toothed timing drive belt (excluding 1.3 Multijet engine)XX
Replace toothed timing drive belt (*) (excluding 1.3 Multijet engine)X
Replace spark plugs (petrol versions)XXXXXX
Check operation of engine management systems (using diagnostic socket)XXXXXX
Check manual gearbox fluid levelXX
Replace engine oil and oil filter (petrol versions)XXXXXX
Replace engine oil and oil filter (Multijet version with DPF) (**)
Change brake fluid (or every 2 years)XXX
Change pollen filter (or every year)XXXXXX
Check exhaust emissions/fumes (1.3 Multijet engine)XXXXXX
Replace fuel filter cartridge (Green-filter) (1.3 Multijet engine)XXX

(*) Or every 4 years for heavy usage (cold climates, town driving with long idling stops, dusty areas)

Or every 5 years, irrespective of the mileage

(**) The engine oil and filter should be replaced when the warning light in the instrument panel comes on or every 2 years.

If the vehicle is used mainly around town or the annual km is less than 10,000 km, the engine oil and engine oil filter must be changed every 12 months.

Parts & tools for this job For 2007 Fiat 500

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.