AERIAL SUPPORT - R.R

Operation 5570T27 · CAR RADIO/CAR TELEPHONE/VIDEO

Removing

- Remove the rear handles.

Op. 7065C30 GRAB HANDLE (ONE) LEFT, RIGHT OR CENTRE PASSENGER COMPARTMENT INTERIOR - R.R

- Remove the left and right courtesy lights.

Op. 7040E14 L/H OR R/H SIDE COURTESY LIGHT (ONE) - R+R

Op. 7040H80 REAR PARCEL SHELF - R.R.

Op. 7040G30 BOOT LIGHT BULB HOLDER - R.R.

1. Release the seals (1a) for the rear door housing (1b) and the tailgate housing in the area of the remaining left rear trim.

2. Remove the trim (2a) from the backrest retainer striker.

3. Undo the bolts securing the left side cover.

4. Release the inner retainers (4a) for the side trim (4b) using the special tool.

5. Lower the left side trim (4b) without releasing it from the rear seat belt (5a).

- Also lower the right rear side trim, repeating the operations in points 1 to 5.

1. Release the door housing seals in the area of the left upper centre pillar cover.

2. Release the bolt cover.

3. Undo the bolt.

4. Move the left upper pillar cover (4a) by releasing internal retainers (4b).

5. Lower the upper pillar cover (4a), without releasing it from the seat belt (5a).

- Also lower the right upper centre pillar cover, repeating the operations in points 1 to 5.

1. Prise up the rear door housing seal in the area of the roof lining.

2. Undo the bolts (2a) and remove side courtesy light housings (2b).

1. Gently lower the roof lining.

2. Disconnect the connection for the aerial lead.

3. Undo the special nut with the split washer.

1. Working from outside the vehicle, remove the aerial mounting and wiring

Refitting

- Check that the aerial mounting is not damaged.

- Fit the wiring, then position the aerial mounting and secure it from the inside using the special nut.

- Connect the connection for the aerial lead.

- Position the roof lining.

- Position the side courtesy light housings and tighten the bolts.

- Positino the roof lining and fit the rear door housing seal in the area of the roof lining.

- Lift up the left upper centre pillar cover.

Position the let upper centre pillar cover and engage the inner retainers.

Tighten the bolt.

Fit the bolt cover.

Fit the door housing seals.

- Lift up the right upper centre pillar cover.

Position the let upper centre pillar cover and engage the inner retainers.

Tighten the bolt. Fit the bolt cover.

Fit the door housing seals.

- Position the left rear side cover.

Position the left rear side cover and attach the inner retainers.

Tighten the bolts securing the cover.

Position the backrest retainer striker panel and engage the retainers.

Fit the seals for the rear door housing and tailgate housing.

- Position the right rear side cover.

Position the left rear side cover and attach the inner retainers.

Tighten the bolts securing the cover.

Position the backrest retainer striker panel and engage the retainers.

Fit the seals for the rear door housing and tailgate housing.

Op. 7040G30 BOOT LIGHT BULB HOLDER - R.R.

Op. 7040H80 REAR PARCEL SHELF - R.R.

Op. 7040E14 L/H OR R/H SIDE COURTESY LIGHT (ONE) - R+R

Op. 7065C30 GRAB HANDLE (ONE) LEFT, RIGHT OR CENTRE PASSENGER COMPARTMENT INTERIOR - R.R

POWERED SUNROOF

Removing

Op. 7040H80 REAR PARCEL SHELF - R.R.

Op. 7040G30 BOOT LIGHT BULB HOLDER - R.R.

Op. 7040H30 FRONT PILLAR TRIM (ONE), LEFT OR RIGHT - R.R.

Op. 7040H38 CENTRE PILLAR UPPER ELEMENT (ONE), LEFT OR RIGHT - R.R

Op. 7040H66 LEFT REAR SIDE TRIM, WITH REAR PARCEL SHELF SUPPORT - R.R.

Op. 7040H67 RIGHT REAR SIDE TRIM, WITH REAR PARCEL SHELF SUPPORT - R.R.

Op. 7040E12 CENTRE COURTESY LIGHT - R+R

Op. 7030B64 SUN ROOF CONTROL SWITCH - R+R

Op. 7040E10 FRONT COURTESY LIGHT - R+R

- Remove the sun blinds.

Op. 7065C34 SUN BLIND (ONE), LEFT OR RIGHT - R.R.

- Remove all the grab handles.

Op. 7065C30 GRAB HANDLE (ONE) LEFT, RIGHT OR CENTRE PASSENGER COMPARTMENT INTERIOR - R.R

Op. 7030B32 SLIDING ROOF DECORATIVE SEAL(1) FRONT OR REAR - R R

- Recline the front seat backrests into the end of travel position.

1. Undo the bolt (1a) and remove the middle courtesy light housing (1b).

2. Prise up the door housing seals in the area of the roof lining.

3. Lower the roof lining.

- Remove the radio aerial undoing it from the support.

1. Disconnect the connections for the radio aerial supply leads (1a) and for the coaxial cable (1b).

2. Undo the special nut with the split washer.

3. Working via the roof of the vehicle, remove the aerial support (3a) complete with cables (3b).

Refitting

- Check that the aerial support and cables are not damaged.

- Fit the cables, then position the aerial mounting and secure it from the inside using the special nut.

- Connect the aerial lead connections.

- Fit the radio aerial and tighten it.

- Position the roof lining and fit the door housing seals.

- Place the middle courtesy light in position and tighten the bolt.

- Place the front seats back into the normal position.

Op. 7030B32 SLIDING ROOF DECORATIVE SEAL(1) FRONT OR REAR - R R

Op. 7065C30 GRAB HANDLE (ONE) LEFT, RIGHT OR CENTRE PASSENGER COMPARTMENT INTERIOR - R.R

Op. 7065C34 SUN BLIND (ONE), LEFT OR RIGHT - R.R.

Op. 7040E10 FRONT COURTESY LIGHT - R+R

Op. 7030B64 SUN ROOF CONTROL SWITCH - R+R

Op. 7040E12 CENTRE COURTESY LIGHT - R+R

Op. 7040H67 RIGHT REAR SIDE TRIM, WITH REAR PARCEL SHELF SUPPORT - R.R.

Op. 7040H66 LEFT REAR SIDE TRIM, WITH REAR PARCEL SHELF SUPPORT - R.R.

Op. 7040H38 CENTRE PILLAR UPPER ELEMENT (ONE), LEFT OR RIGHT - R.R

Op. 7040H30 FRONT PILLAR TRIM (ONE), LEFT OR RIGHT - R.R.

Op. 7040G30 BOOT LIGHT BULB HOLDER - R.R.

Op. 7040H80 REAR PARCEL SHELF - R.R.