Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat Bravo Factory Service Manual (2007-2014)22 · Fault diagnosis
22 · Diagnostics

Irregular operation of voice recognition

Make
Fiat
Model
Bravo Factory Service Manual
Year
2007–2014
Section
Radio and accessories etc. › Irregular operation of voice recognition
Fault diagnosisIrregular operation of voice recognition

IRREGULAR OPERATION OF VOICE RECOGNITION

Blue&Me

The voice commands function is managed by the telephone module which is incorporated in the Bluetooth. Whilst the microphone is located outside on the control panel

TEST RESULTS
1ACTIVE DIAGNOSIS CHECKALL OKPROBLEMS ENCOUNTEREDACTION

Connect to the Bluetooth node using the Examiner and select Configurations in Active Diagnosis

Carry out the Audio system test and check whether the radio produces a BIP noise

Move on to Step 2There is no BIP noise from the radioMove on to Step 3
2MICROPHONE CONNECTIONS CHECKALL OKPROBLEMS ENCOUNTEREDACTION

Check the continuity and the insulation of the electrical circuit between the microphone and the Bluetooth control unit

See E4090 NAVIGATOR

Check that the microphone is working properly

Move on to Step 3

1. Microphone not correctly connected.

2. Wiring between microphone and Bluetooth broken

3. Microphone defective

1. Restore the correct connection

2. Restore wiring continuity

3. Replace the control panel complete with microphone

Op. 5580M20 ON BOARD NAVIGATION SYSTEM CONTROLS - R.R.

3CHECK THE WIRINGALL OKPROBLEMS ENCOUNTEREDACTION

Check the continuity of the connections between the Bluetooth and the radio

Check that the power supply for the Bluetooth is correct

See E4090 NAVIGATOR

Check that the radio is correctly supplied

See E3510 RADIO

End of diagnosis

1. Wiring broken

2. Bluetooth power supply not correct

3. Radio power supply not correct

4. Bluetooth defective

1. Restore the continuity of the connections between the Bluetooth node and the radio

See E4090 NAVIGATOR

2. Restore correct power supply for the Bluetooth

3. Restore the correct power supply for the radio.

4. If no faults have been found during the previous checks, replace the Bluetooth node

Op. 5570T49 BLUETOOTH ELECTRONIC CONTROL UNIT - R.R.

Parts & tools for this job For 2007 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.