Workshop Manuals Factory service & repair Fiat
Fiat Punto (176) Factory Service Manual (1993-1999)08 · 50 Auxiliary units
08 · General

Disassembly (page 2 of 2)

Make
Fiat
Model
Punto (176) Factory Service Manual
Year
1993–1999
Section
Manually controlled heater
50 Auxiliary unitsDisassembly · page 2 of 2
Diagram of the auxiliary unit assembly showing numbered components 9, 10, 11, 12, and 13
Diagram of the auxiliary unit assembly showing numbered components 14, 15, 16, 17, and 18
Diagram of the auxiliary unit assembly showing numbered components 19, 20, and 21
  • disconnect the two connectors (9);
  • disconnect connector (10) from connector of terminal leads of electric actuator (motor) responsible for operating air intake flap;
  • disconnect connectors (11 - 12 and 13) from fan base, resistor and compressor ECU respectively;
  • unscrew screws (14 - 15 and 17) that fasten the two connectors (16) and bracket with blocks to which the two relays (18) are connected to the left side surface of the assembly;
  • release electrical wiring from hook clips (indicated by small arrows) applied to the above assembly;
  • unscrew screw (19) that fastens bracket (20) retaining the two pipes (21) connected to the expansion valve and evaporator outlet duct to rear assembly surface;
  • unscrew screws indicated by large arrows in the various figures on this page that fasten the central evaporator unit (A) to fan (B) and distributor heater (C).
Diagram of the auxiliary unit assembly showing locations of screws indicated by large arrows
Diagram of the auxiliary unit assembly identifying the central evaporator unit (A), fan (B), and distributor heater (C)

Parts & tools for this job For 1993 Fiat Punto

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.