Control cable and blower motor switch

CONTROL CABLE AND BLOWER MOTOR SWITCH

Service repair no - 80.10.17 - Control cable Service repair no - 80.10.22 - Blower motor switch

Remove

1. Disconnect battery.
8. Release lever assembly and disconnect 3 blower motor leads, noting their positions.
9. Pull control cable through bulkhead grommet and out from instrument binnacle cowl.
10. Release retaining clip securing outer cable to
11. Release inner cable from lever peg.
2. From inside engine compartment, release outer cable retaining clip at heater unit.
3. Slacken trunnion fixing and release inner cable from heater unit flap lever. Refit
4. Release 2 retaining clips securing control cables to engine bulkhead and heater hoses. 12. Fit control cable to lever assembly peg.
13. Fit retaining clip to secure outer cable.
14. Reconnect blower motor leads.
15. Route cable to rear of instrument panel cowl,

16. Fit lever assembly to instrument panel cowl.
17. Fit instrument binnacle to fascia cowl.
18. With lever in closed position, fit control cable to
19. Secure outer cable with retaining clip.
20. Secure control cables to engine bulkhead and
21. Reconnect battery.
5. Remove 4 screws securing instrument panel to fascia cowl.
6. Pull instrument binnacle away from fascia to ease access to control cable.
7. Remove 2 screws securing control lever assembly to side of fascia binnacle cowl. Retain plastic screw spacers fitted between cowl and lever assembly.

lever assembly.

NOTE: Renew complete lever assembly if the blower motor switch is faulty.

along bulkhead and out through grommet into engine compartment.

Ensure screw spacers are fitted between cowl and lever assembly.

heater unit flap lever trunnion.

heater hoses with retaining clips.