TD5 Defender
BRAKES
3
REPAIR
SENSORS - ABS - REAR WHEELS
Service repair no - 70.65.31
Remove
1. Raise vehicle on a 2 post ramp.
2. Remove both rear wheels.
3. Remove 3 bolts securing each brake disc
backplate to hub assemblies.
4. Remove both back plates.
5. Remove 2 cable ties securing sensor harness to
outer ends of axle.
6. Carefully prise both sensors from hub
assemblies.
7. Release 4 clips securing sensor harness to axle.
8. Release cable tie securing harness to
differential.
9. Release 3 cable ties securing harness to chassis
longitudinal.
10. Disconnect sensor multiplug.
11. Remove harness and sensor assembly.
Refit
12. Position harness and sensor assembly to vehicle
and connect multiplug.
13. Apply grease to both sensors.
14. Carefully fit both sensors to hub assemblies.
15. Secure harness to axle and differential with
cable ties.
16. Secure harness to axle with clips.
17. Secure harness to chassis with cable ties.
18. Fit both back plates to hub assemblies and
secure with bolts.
19. Fit rear wheels and tighten to 130 Nm (95 lbf.ft)
.
20. Lower vehicle.